Bangarang · Tesla Light Show
by Skrillex ft. Sirah
The synth stabs are already a light pattern, so the show mostly gets out of the way and fires them: signature bar leading, tail lights close behind, the whole body on the drop. At 1.4 light changes a second it sits among the fastest handful in the catalog, and it runs bright, which together make it about as loud as this car can be made to look. The middle third carries the most, so the second drop is the one to wait for. Skrillex in 2011, still the template everything else copies.
How this one is choreographed
This is one of the fastest shows in the library: the lights re-fire about 1.4 times a second and rarely sit still. The peak is in the middle third, where roughly 40% of the car is lit against 39% at the top, then it eases back for the finish. The fullest ten seconds come early, starting at 0:24 with about 43% of the car lit, so have people watching from the first bar. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.8 times a second, with the side markers answering back at 1.6. The work is split close to evenly between the two ends, 51% front to 49% rear, so it plays from either end, or side-on from the curb. The quietest part of the car is the inner main beams, at about 0.8 re-fires a second. It runs 3:35 and averages 88 of 255 across the light channels, a bright show that stays close to full through its busiest passages. The values are mostly hard on or hard off, only about 14% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot. It never goes completely dark for long: the longest gap is 0.8 of a second, just before the close.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
