Can't Hold Us · Tesla Light Show
by Macklemore & Ryan Lewis ft. Ray Dalton
Macklemore and Ryan Lewis with Ray Dalton on the hook, and a chorus written to be shouted from the back of a stadium. This is one of the fastest-firing shows in the catalog: the signature bar re-fires nearly twice a second through the verses, with the tail lights chasing it. It builds through the run and is one of the brightest shows here, close to full at its peak, which is what that last chorus deserves. Four minutes seventeen. Start it when you want the whole street to look over.
How this one is choreographed
This is one of the fastest shows in the library: the lights re-fire about 1.5 times a second and rarely sit still. It builds. The car runs about 37% of its lights through the opening third and finishes near 43%, so the biggest picture is the one you end on. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.9 times a second, with the tail lights answering back at 1.6. It runs 4:17 and averages 94 of 255 across the light channels, a bright show that stays close to full through its busiest passages. About 22% of the light values are partial, toward the top of the range for this catalog, so the show leans on swells and dimming as much as on hits.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
