Celebration · Tesla Light Show
by Kool & The Gang
The default party record since 1980, and the show is built to last the whole night rather than peak once: it holds one level from start to finish, with a quarter of its values at a partial level so everything glows and fades instead of snapping. It is one of the darker runs here, front-signal led with the rear signals answering, which spreads it around the car. Five minutes, which is the longest of the New Year's picks. Good times, and the show does not pretend to be anything cleverer.
How this one is choreographed
This is a busy show. The lights re-fire about 0.9 times a second, near the top of what the catalog runs. It holds a level: right around 29% of the car stays lit from start to finish, with no single section stealing the show. Most of the work falls on the front turn signals, re-firing about 1.2 times a second, with the rear turn signals answering back at 1.2. It runs 4:58 and averages 53 of 255 across the light channels, a darker show that spends most of its time well below full, so the hits carry further. About 25% of the light values are partial, toward the top of the range for this catalog, so the show leans on swells and dimming as much as on hits.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
