Dynamite · Tesla Light Show
by BTS
Disco-pop engineered in a laboratory for maximum shine, and the show matches: bright, fast-firing, signature bar leading with the side markers filling underneath. It peaks through the middle and runs under three and a half minutes, which makes it one of the tighter New Year's picks here. Nothing about it is subtle and nothing about it is trying to be. If your street has children in it, this is the one they will ask you to run again, and it is short enough that you can.
How this one is choreographed
This is one of the fastest shows in the library: the lights re-fire about 1.4 times a second and rarely sit still. The peak is in the middle third, where roughly 42% of the car is lit against 35% at the top, then it eases back for the finish. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.7 times a second, with the side markers answering back at 1.6. It runs 3:26 and averages 87 of 255 across the light channels, a bright show that stays close to full through its busiest passages. About 17% of the light values sit at a partial level, so hits are punctuated by fades rather than being pure on and off.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
