Bye Bye Bye · Tesla Light Show
by *NSYNC
The three "bye bye bye" hits are the moment everyone waits for, and the show punches all three, full car, every single time, with tight boy-band bounce holding the verses together in between. It is a quick, tightly packed run, tail-led, with about a fifth of its values sitting partial so the bounce has some give in it. The middle is where it opens widest. Three minutes and twenty seconds from the year 2000, and if anyone in the crowd does the marionette arms, that is the show working as intended.
How this one is choreographed
This is one of the fastest shows in the library: the lights re-fire about 1.2 times a second and rarely sit still. The peak is in the middle third, where roughly 38% of the car is lit against 28% at the top, then it eases back for the finish. The fullest ten seconds arrive late, starting at 3:01 with about 43% of the car lit, so keep the camera rolling to the end. Most of the work falls on the tail lights, re-firing about 1.6 times a second, with the front turn signals answering back at 1.3. About 55% of the re-firing happens at the rear, so the better view is from behind the car. The quietest part of the car is the inner main beams, at about 0.8 re-fires a second. It runs 3:20 and averages 72 of 255 across the light channels, a mid-brightness show, with real headroom kept in reserve for the peaks. About 21% of the light values are partial, toward the top of the range for this catalog, so the show leans on swells and dimming as much as on hits. The longest full blackout lasts 1.5 seconds, just before the close, and that pause is what makes the next hit land.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
