One More Time · Tesla Light Show
by Daft Punk
Daft Punk's 2000 anthem: a filtered horn loop, Romanthony's voice run through a vocoder, and a long ambient breakdown right in the middle. The show dips into that breakdown with the song, then comes back stronger, finishing wider than it starts. The signature bar leads at a relentless clip with the front turn signals answering, at mid-brightness across five minutes twenty. It is tagged for New Year's Eve for the obvious reason, and it pairs well with Stronger, which samples the same duo.
How this one is choreographed
This is one of the fastest shows in the library: the lights re-fire about 1.1 times a second and rarely sit still. It builds. The car runs about 34% of its lights through the opening third and finishes near 36%, so the biggest picture is the one you end on. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.4 times a second, with the front turn signals answering back at 1.3. It runs 5:20 and averages 74 of 255 across the light channels, a mid-brightness show, with real headroom kept in reserve for the peaks. About 16% of the light values sit at a partial level, so hits are punctuated by fades rather than being pure on and off.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
