Party in the U.S.A. · Tesla Light Show
by Miley Cyrus
Relentlessly cheerful and choreographed without a hint of irony. The signature bar leads, the front signals answer, and it genuinely builds, finishing wider than it opens, so the last chorus is the biggest picture in the run. Bright, quick, and three and a half minutes long. Tagged for the fourth of July alongside the more serious American picks here, and it is deliberately the least serious of them. If you want the driveway singing rather than saluting, this is the one to reach for.
How this one is choreographed
This is one of the fastest shows in the library: the lights re-fire about 1.1 times a second and rarely sit still. It builds. The car runs about 31% of its lights through the opening third and finishes near 38%, so the biggest picture is the one you end on. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.3 times a second, with the front turn signals answering back at 1.2. It runs 3:22 and averages 82 of 255 across the light channels, a bright show that stays close to full through its busiest passages. The values are mostly hard on or hard off, only about 13% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
