ph wav · Tesla Light Show
COMMUNITYChoreographed by Barry Scholnick and reviewed by us
A community submission built on a Model 3 at 111 BPM using the rock mix preset, and one of the shorter runs in the catalog at two minutes and fifty-one seconds. It fires at a busy clip, leads with the signature bar and the front turn signals, and genuinely builds, finishing wider than it opens, so the last third is where it puts its weight. The values are mostly hard on or hard off, which gives it a percussive read from a distance. A straightforward, unfussy show, and a clear look at what the rock preset does to a track.
How this one is choreographed
The lights re-fire about 0.8 times a second, a middle pace that tracks the beat without crowding it. It builds. The car runs about 28% of its lights through the opening third and finishes near 35%, so the biggest picture is the one you end on. Most of the work falls on the signature light bar and daytime running lights, re-firing about 0.9 times a second, with the front turn signals answering back at 0.9. It runs 2:51 and averages 74 of 255 across the light channels, a mid-brightness show, with real headroom kept in reserve for the peaks. The values are mostly hard on or hard off, only about 15% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
