Rollin' (Air Raid Vehicle) · Tesla Light Show
by Limp Bizkit
Limp Bizkit's 2000 single, all bounce and bravado, and for a few years the entrance music for half the arenas in America. The show keeps rollin: the signature bar and side markers both re-fire well over once a second, and it holds one level across four and a half minutes rather than climbing. Bright and hard-edged, with only about an eighth of the values partial, so every hit is a clean on or off. Nu metal at full confidence. It sits well next to Last Resort and Numb for a turn-of-the-century block.
How this one is choreographed
This is one of the fastest shows in the library: the lights re-fire about 1.1 times a second and rarely sit still. It holds a level: right around 37% of the car stays lit from start to finish, with no single section stealing the show. The fullest ten seconds come early, starting at 0:21 with about 40% of the car lit, so have people watching from the first bar. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.3 times a second, with the side markers answering back at 1.3. About 55% of the re-firing happens at the front of the car, so park with the nose toward the audience. The quietest part of the car is the rear turn signals, at about 0.8 re-fires a second. It runs 4:35 and averages 89 of 255 across the light channels, a bright show that stays close to full through its busiest passages. The values are mostly hard on or hard off, only about 12% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot. It never goes completely dark for long: the longest gap is 0.8 of a second, at 3:33.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
