SICKO MODE · Tesla Light Show
by Travis Scott ft. Drake
Three songs wearing a trench coat, and the beat switches are the entire reason to run it. The show tracks each section rather than smoothing them together, so the changes actually read as changes. It holds one level across the full five minutes instead of building, which suits a track that keeps restarting itself. One of the darker runs here, front-signal led, with a fifth of the values fading rather than switching. A 30-second preview could never show what this does; five minutes can.
How this one is choreographed
This is a busy show. The lights re-fire about 1.1 times a second, near the top of what the catalog runs. It holds a level: right around 30% of the car stays lit from start to finish, with no single section stealing the show. Most of the work falls on the front turn signals, re-firing about 1.4 times a second, with the signature light bar and daytime running lights answering back at 1.3. It runs 5:13 and averages 60 of 255 across the light channels, a darker show that spends most of its time well below full, so the hits carry further. About 22% of the light values are partial, toward the top of the range for this catalog, so the show leans on swells and dimming as much as on hits.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
