Titanium · Tesla Light Show
by David Guetta ft. Sia
One long climb to one enormous release, and the show refuses to spend anything early. The cues sit far apart through the verses, landing as separate moments, and the side markers carry it, so the build spreads around the whole body instead of pointing at you from the front. It is a bright show that peaks through the middle. Four minutes. Sia's vocal does most of the work and the choreography plainly knows it, which is why this reads as restraint rather than as a show with nothing to give.
How this one is choreographed
The choreography is deliberately unhurried: the lights re-fire about 0.6 times a second, so cues land as separate moments rather than a blur. The peak is in the middle third, where roughly 39% of the car is lit against 36% at the top, then it eases back for the finish. Most of the work falls on the side markers, re-firing about 0.8 times a second, with the signature light bar and daytime running lights answering back at 0.7. It runs 4:05 and averages 88 of 255 across the light channels, a bright show that stays close to full through its busiest passages. The values are mostly hard on or hard off, only about 13% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
