See You Again · Tesla Light Show
by Wiz Khalifa ft. Charlie Puth
The piano hook glows soft and steady, the rap verses pick the rhythm up across the body, and every "see you again" chorus swells the full car. Written for the end of Furious 7 as a farewell to Paul Walker, and the choreography stays respectful about it: no strobing, nothing that turns the song into a party it was never meant to be. It is one of the darker shows here, which suits the material, with the signature bar leading and about a fifth of the values fading rather than switching. Just under four minutes.
How this one is choreographed
The lights re-fire about 0.8 times a second, a middle pace that tracks the beat without crowding it. The peak is in the middle third, where roughly 32% of the car is lit against 30% at the top, then it eases back for the finish. The fullest ten seconds come early, starting at 0:40 with about 43% of the car lit, so have people watching from the first bar. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.0 times a second, with the tail lights answering back at 1.0. The work is split close to evenly between the two ends, 47% front to 53% rear, so it plays from either end, or side-on from the curb. The quietest part of the car is the inner main beams, at about 0.5 re-fires a second. It runs 3:50 and averages 60 of 255 across the light channels, a darker show that spends most of its time well below full, so the hits carry further. About 21% of the light values are partial, toward the top of the range for this catalog, so the show leans on swells and dimming as much as on hits. The longest full blackout lasts 1.3 seconds, just before the close, and that pause is what makes the next hit land.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
