X Gon' Give It to Ya · Tesla Light Show
by DMX
Slow, heavy and enormous. The show works the signature bar with the front signals answering, and because the beat leaves so much space between hits, every one of them lands full-body with nothing competing. It runs at a busy cue rate over a very unhurried tempo, which is an odd combination on paper and reads as pure menace on a car. Peaks through the middle, three and a half minutes. There is no graceful way to say this: it is the best entrance music in the library.
How this one is choreographed
This is a busy show. The lights re-fire about 1.0 times a second, near the top of what the catalog runs. The peak is in the middle third, where roughly 35% of the car is lit against 29% at the top, then it eases back for the finish. The fullest ten seconds come early, starting at 0:29 with about 37% of the car lit, so have people watching from the first bar. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.4 times a second, with the front turn signals answering back at 1.4. About 56% of the re-firing happens at the front of the car, so park with the nose toward the audience. The quietest part of the car is the inner main beams, at about 0.6 re-fires a second. It runs 3:35 and averages 77 of 255 across the light channels, a mid-brightness show, with real headroom kept in reserve for the peaks. The values are mostly hard on or hard off, only about 15% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot. Once it starts there is no full blackout at all: at least one light is on the whole way through.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
