Immigrant Song · Tesla Light Show
by Led Zeppelin
Robert Plant's opening wail and that galloping riff: the 1970 Led Zeppelin song about Vikings that film trailers still borrow whenever they need an entrance. The show gallops with it, the side markers leading around the body with the tail lights answering, steady and driving, and the fullest stretch sits in the middle. It runs bright, close to full, and it is barely two and a half minutes long, so it hits and leaves. Very hard-edged, with values mostly on or off rather than fading.
How this one is choreographed
The lights re-fire about 0.7 times a second, a middle pace that tracks the beat without crowding it. The peak is in the middle third, where roughly 40% of the car is lit against 35% at the top, then it eases back for the finish. Most of the work falls on the side markers, re-firing about 0.8 times a second, with the tail lights answering back at 0.8. It runs 2:27 and averages 91 of 255 across the light channels, a bright show that stays close to full through its busiest passages. The values are mostly hard on or hard off, only about 11% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
