Song 2 · Tesla Light Show
by Blur
Blur wrote it in 1997 as a joke about grunge, and it became the stadium anthem with the woo-hoo everybody shouts. Two minutes of quiet-loud contrast, and the show plays that contrast: cues spaced far apart, the front turn signals leading at a deliberate pace with the signature bar answering, so each explosion of the chorus lands as its own event. It builds through the run and is one of the shortest shows here, hard-edged, almost all on or off. Short, loud and done before anyone gets bored.
How this one is choreographed
The choreography is deliberately unhurried: the lights re-fire about 0.4 times a second, so cues land as separate moments rather than a blur. It builds. The car runs about 30% of its lights through the opening third and finishes near 37%, so the biggest picture is the one you end on. Most of the work falls on the front turn signals, re-firing about 0.5 times a second, with the signature light bar and daytime running lights answering back at 0.4. It runs 2:02 and averages 79 of 255 across the light channels, a mid-brightness show, with real headroom kept in reserve for the peaks. The values are mostly hard on or hard off, only about 12% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
