Livin' on a Prayer · Tesla Light Show
by Bon Jovi
The key change is the whole event, and the show saves everything for it. Cues sit far apart through the verses, tail-led with the brake light answering, so the car stays low and patient while the story does its work. Then the modulation arrives and the front opens. It peaks through the middle and runs four and a half minutes at a genuinely unhurried rate, one of the calmer cue rates in the catalog, which is what makes the lift land rather than get lost in motion. Halfway there, and the neighbours will be singing.
How this one is choreographed
The choreography is deliberately unhurried: the lights re-fire about 0.4 times a second, so cues land as separate moments rather than a blur. The peak is in the middle third, where roughly 40% of the car is lit against 34% at the top, then it eases back for the finish. Most of the work falls on the tail lights, re-firing about 0.5 times a second, with the brake light answering back at 0.5. It runs 4:23 and averages 83 of 255 across the light channels, a bright show that stays close to full through its busiest passages. The values are mostly hard on or hard off, only about 13% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
