Marry You · Tesla Light Show
by Bruno Mars
The one show here with an actual job to do. This is the song people propose to, and the choreography treats the moment properly: side markers carrying a bright, quick sparkle right around the body rather than a front-of-car spotlight, so it reads from whatever angle somebody happens to be standing at. It runs bright, peaks through the middle, and moves faster than the tempo suggests. Just under four minutes, which is about as long as anyone can hold a ring out. Tagged for weddings, and made for exactly that.
How this one is choreographed
This is one of the fastest shows in the library: the lights re-fire about 1.1 times a second and rarely sit still. The peak is in the middle third, where roughly 44% of the car is lit against 38% at the top, then it eases back for the finish. If you are filming, the fullest ten seconds start at 1:32, when about 47% of the car is lit at once. Most of the work falls on the side markers, re-firing about 1.5 times a second, with the signature light bar and daytime running lights answering back at 1.2. The work is split close to evenly between the two ends, 51% front to 49% rear, so it plays from either end, or side-on from the curb. The quietest part of the car is the rear turn signals, at about 0.8 re-fires a second. It runs 3:50 and averages 89 of 255 across the light channels, a bright show that stays close to full through its busiest passages. About 21% of the light values are partial, toward the top of the range for this catalog, so the show leans on swells and dimming as much as on hits. It never goes completely dark for long: the longest gap is 0.4 of a second, just before the close.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
