Mr. Brightside · Tesla Light Show
by The Killers
One of the brightest shows in the catalog, averaging 98 of 255 across the light channels, which makes it one that carries a long way down a street and a safe pick for an evening that is not fully dark yet. That single guitar line runs the whole song, so the show does not chase it: unhurried cues on the side markers and tail lights, nearly all of them hard on or hard off. It peaks through the middle. Three and three quarter minutes. Everyone in the driveway knows every word, which is the real point.
How this one is choreographed
The choreography is deliberately unhurried: the lights re-fire about 0.6 times a second, so cues land as separate moments rather than a blur. The peak is in the middle third, where roughly 43% of the car is lit against 37% at the top, then it eases back for the finish. The fullest ten seconds come early, starting at 0:31 with about 43% of the car lit, so have people watching from the first bar. Most of the work falls on the tail lights, re-firing about 0.8 times a second, with the side markers answering back at 0.7. The work is split close to evenly between the two ends, 50% front to 50% rear, so it plays from either end, or side-on from the curb. The quietest part of the car is the rear turn signals, at about 0.4 re-fires a second. It runs 3:43 and averages 98 of 255 across the light channels, a bright show that stays close to full through its busiest passages. The values are mostly hard on or hard off, only about 11% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot. The longest full blackout lasts 1.7 seconds, at 0:06, and that pause is what makes the next hit land.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
