Birthday · Tesla Light Show
by The Beatles
They say it's your birthday, and the Beatles cut this one in a single evening in 1968. It is a guitar riff and a drum break more than a song, and the show treats it that way: the signature bar and running lights take the riff, the tail lights answer, and the busiest stretch lands in the middle during the drum break. It is one of the brightest shows here, averaging close to full, so it carries across a yard. Two minutes forty-three of rock and roll birthday.
How this one is choreographed
This is a busy show. The lights re-fire about 1.0 times a second, near the top of what the catalog runs. The peak is in the middle third, where roughly 43% of the car is lit against 35% at the top, then it eases back for the finish. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.2 times a second, with the tail lights answering back at 1.2. It runs 2:43 and averages 95 of 255 across the light channels, a bright show that stays close to full through its busiest passages. The values are mostly hard on or hard off, only about 13% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
