We Don't Talk About Bruno · Tesla Light Show
by Encanto Cast
The Encanto ensemble number that went to number one in 2022, each family member taking a verse about the uncle nobody mentions. The show layers the way the song does: the side markers lead with the front turn signals answering at a steady pace, and it builds through the run, so the finale, where every melody is sung at once, is the fullest stretch. It sits in the darker half of the catalog, three minutes forty-two. Expect the kids to take a part each, and expect all of them to want Camilo's.
How this one is choreographed
The lights re-fire about 0.7 times a second, a middle pace that tracks the beat without crowding it. It builds. The car runs about 27% of its lights through the opening third and finishes near 33%, so the biggest picture is the one you end on. If you are filming, the fullest ten seconds start at 2:39, when about 40% of the car is lit at once. Most of the work falls on the side markers, re-firing about 0.9 times a second, with the front turn signals answering back at 0.8. The work is split close to evenly between the two ends, 51% front to 49% rear, so it plays from either end, or side-on from the curb. The quietest part of the car is the brake light, at about 0.4 re-fires a second. It runs 3:42 and averages 63 of 255 across the light channels, a darker show that spends most of its time well below full, so the hits carry further. About 16% of the light values sit at a partial level, so hits are punctuated by fades rather than being pure on and off. It never goes completely dark for long: the longest gap is 0.6 of a second, at 3:38.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
