We Will Rock You · Tesla Light Show
by Queen
Stomp, stomp, clap. Two minutes and two seconds, which makes this the shortest show in the catalog, and it needs not one second more. The lights hold that stomp pattern on the tail lights and side markers with almost nothing in between, hard on and hard off, so the gap is as much of it as the hit is. It builds through the run to finish at its widest, arriving exactly where the guitar solo does. The only show in the library a crowd can perform along with rather than just watch.
How this one is choreographed
The lights re-fire about 0.7 times a second, a middle pace that tracks the beat without crowding it. It builds. The car runs about 26% of its lights through the opening third and finishes near 37%, so the biggest picture is the one you end on. Most of the work falls on the tail lights, re-firing about 0.8 times a second, with the side markers answering back at 0.8. It runs 2:02 and averages 74 of 255 across the light channels, a mid-brightness show, with real headroom kept in reserve for the peaks. The values are mostly hard on or hard off, only about 12% of samples sitting at a partial level, which reads sharp and percussive from across a parking lot.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
