Boot Scootin' Boogie · Tesla Light Show
by Brooks & Dunn
The song that turned half of 1992 into a line dance. Brooks & Dunn's honky-tonk stomp has a beat you can count off, and the show counts it: the signature bar and running lights keep time with the front turn signals answering on the offbeat, steady rather than rushed. It genuinely builds, the final third its fullest, and it runs bright enough to read from the back of a crowd. Three minutes eighteen, made for tailgates, barn parties and anywhere somebody has already started the grapevine.
How this one is choreographed
The lights re-fire about 0.8 times a second, a middle pace that tracks the beat without crowding it. It builds. The car runs about 30% of its lights through the opening third and finishes near 36%, so the biggest picture is the one you end on. Most of the work falls on the signature light bar and daytime running lights, re-firing about 1.0 times a second, with the front turn signals answering back at 0.9. It runs 3:18 and averages 80 of 255 across the light channels, a mid-brightness show, with real headroom kept in reserve for the peaks. About 17% of the light values sit at a partial level, so hits are punctuated by fades rather than being pure on and off.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
