4x4xU · Tesla Light Show
by Lainey Wilson
A swampy mid-tempo groove with the pocket sitting well behind the beat, and the lights ride there with it: warm rolling patterns that let the hook do all the flexing. The tail lights lead and the side markers answer, which keeps the whole thing low and wide rather than up front and bright. It runs a clean four minutes and peaks through the middle before easing out. More boot-tap than fist-pump, entirely on purpose. If you want the country side of the catalog at its most relaxed, this is the one to reach for after dark.
How this one is choreographed
The lights re-fire about 0.7 times a second, a middle pace that tracks the beat without crowding it. The peak is in the middle third, where roughly 36% of the car is lit against 27% at the top, then it eases back for the finish. If you are filming, the fullest ten seconds start at 2:36, when about 40% of the car is lit at once. Most of the work falls on the tail lights, re-firing about 0.8 times a second, with the side markers answering back at 0.8. The work is split close to evenly between the two ends, 50% front to 50% rear, so it plays from either end, or side-on from the curb. The quietest part of the car is the inner main beams, at about 0.5 re-fires a second. It runs 4:00 and averages 72 of 255 across the light channels, a mid-brightness show, with real headroom kept in reserve for the peaks. About 16% of the light values sit at a partial level, so hits are punctuated by fades rather than being pure on and off. It never goes completely dark for long: the longest gap is 0.5 of a second, at 0:05.
Measured from the exported light sequence for this show, not estimated from the song.
Get it for your Tesla
This show downloads for every Tesla: Model 3, Model Y, Model S, Model X, and Cybertruck. Preview it on your model with the View-on picker above, add it to your library, and it re-tailors to your car's lights automatically.
How to play it on your car
- Open the show above and add it to your library (remix it in the builder first if you want).
- Add your own copy of the song: an MP3/WAV you own. We distribute only the light pattern, never audio.
- Export the
.fseqbuilt for your model, then place your song next to it (or let the one-click USB writer do both). - Put both files in a
LightShowfolder on a USB drive. Or skip the manual steps: in Chrome/Edge, click 🔌 Write it to my USB drive for me right after exporting and we do it all, verified byte-for-byte. Then plug in and start it from Toybox → Light Show. Full walkthrough in the setup guide.
Car says Light Show instead of Custom Light Show, or the drive is not detected at all? That is the USB format, the folder name, or filenames that do not match. If it plays but drifts out of time, that is the audio sample rate. Fix both here.
